Turbo 400 yoke

Questions about all other brand differentials.
Butcher455
Newbie Poster
Posts: 4
Joined: Tue Aug 12, 2014 2:59 pm

Turbo 400 yoke

Postby Butcher455 » Wed Sep 16, 2015 12:33 pm

I have a driveshaft for a turbo 400 that is 3/4" too long. Is it possible to shorten the turbo 400 yoke instead of shortening the driveshaft. The yoke is 5 1/2" from center of u-joint to the end of the yoke. It takes the 1350 u-joint if that matters.
Thanks for any help.
Butcher

User avatar
monzaz
Average Poster
Posts: 835
Joined: Tue Nov 13, 2007 7:56 pm
Location: RICHFIELD, OH

Re: Turbo 400 yoke

Postby monzaz » Tue Sep 29, 2015 5:53 am

You should not cut down your yoke. What rear did you replace your original rear with? If drive shaft is original it probably needs a balancing anyway and after they cut it they will do this.

Jim
J D Race


Return to “General Differential Questions”

Who is online

Users browsing this forum: No registered users and 1 guest