s-10 8.8 is HERE!!! pictures and info!!!

Post Reply
User avatar
monzaz
Average Poster
Posts: 984
Joined: Tue Nov 13, 2007 7:56 pm
Location: RICHFIELD, OH

s-10 8.8 is HERE!!! pictures and info!!!

Post by monzaz »

Ok here if what has been requested by alot of customers onthe v8 s-10 forum

8.8 ford 2wd drive and 4wd differentials

specs-
-custom fabricated 8.8 stock fit housing. NOT one modification required!!!!
-Moser 28 or 31 spline axles
-will accept same u-joint from the drive shaft
-NO NO NO drive shaft cutting necessary!!! <<<<<< big deal here....... yippie
-ALL stock drum brake components will fit.
-All stock shock plates and u-bolts and springs can be reused...'
-Stock GM wheels with stock s-10 5 x 4 3/4" bolt pattern can be reused also.

Just very please with the out come.

Here is the proto type of the 2wd 8.8 ford rear Moser 28 spline axle 3.73 and factory ford posi unit.
Attachments
IMG_9056.JPG
IMG_9059.JPG
IMG_9054.JPG
IMG_9053.JPG
J D Race
MWireman
Rookie Poster
Posts: 17
Joined: Sun Aug 21, 2011 3:09 pm
Location: Greenwich,Ohio

Re: s-10 8.8 is HERE!!! pictures and info!!!

Post by MWireman »

how much for the 8.8 S10 rear for a 2wd. Will these be bolt in axles or c-clip?
User avatar
monzaz
Average Poster
Posts: 984
Joined: Tue Nov 13, 2007 7:56 pm
Location: RICHFIELD, OH

Re: s-10 8.8 is HERE!!! pictures and info!!!

Post by monzaz »

Can be either Bolt in axles will always be more as they will be custom ends moser race axles etc. What are you thoughts for truck usage? Power type of driving. Etc. Jim
J D Race
MWireman
Rookie Poster
Posts: 17
Joined: Sun Aug 21, 2011 3:09 pm
Location: Greenwich,Ohio

Re: s-10 8.8 is HERE!!! pictures and info!!!

Post by MWireman »

Was planning on a lot of strip and some street..I figure 3.73 or 4.10 gear ratio...31 spline c-clip would be fine as I only have a 350-400 horse motor. Or maybe a good aftermarket 28 spline posi and Moser axles for the 7.5 rear would probably work too.
Post Reply