I´m in search for cheap & strong strip rear end for my 65 Olds.
Found a 8,5 Bolt from a Blazer, owner say 54" from housing flange to housing flange and 59" overall length....
Correct me if i´m wrong but are those not the same measurement like the rear from 64-67 A Body´s ???
http://www.ebay-kleinanzeigen.de/s-anze ... 6-223-4871
2WD S10 Blazer 8,5 10Bolt
Re: 2WD S10 Blazer 8,5 10Bolt
That is not going to work... The s-10 is leaf spring and the A-body is four link. NOT even in the same world .
You can not just go by length. You have to satay in the same era of rear and same suspension hook up.
A-body 64-72 will interchange... There still will be slight differences in spring perch mounting and u-joint sizes but generally speaking the mounting points for the upper and lower control and shock mounts are all in the same place. Jim
You can not just go by length. You have to satay in the same era of rear and same suspension hook up.
A-body 64-72 will interchange... There still will be slight differences in spring perch mounting and u-joint sizes but generally speaking the mounting points for the upper and lower control and shock mounts are all in the same place. Jim
J D Race
Re: 2WD S10 Blazer 8,5 10Bolt
Jim,sorry for this stupid question... welding a spring perch is not a problem but i dont pay attention to the arm mounting points.
Re: 2WD S10 Blazer 8,5 10Bolt
What thinking about the 8.8 rear from 89er Ford Mustang GT Hatchback Jim?
If i can managed to fit, it must be a strong rear or not...
If i can managed to fit, it must be a strong rear or not...
Re: 2WD S10 Blazer 8,5 10Bolt
Jim, i have a few quest. contact me via Email please : mevido@hotmail.de