I purchased a frankencar and could use some help identifying the rear end, I am not sure if it is a 8.5 Corporate or a 8.2 BOP? Unfortunately when the mounting brackets were ground off they ground off the ID numbers too, two are partially visible, 1st digit is E,F, or L, 2nd digit is B or 8.
Desperately need to replace all the drum brake hardware and do not know what fits?
Thanks for your help,
Chris
Frankencar Rear End?
Re: Frankencar Rear End?
It is either a Camaro 70-81 or Nova 72 -80 Corp 10 bolt 8.5 rear Might be a TRUCK if it was narrowed.
Do you have a width and pictures of the flange end area? jIM
Do you have a width and pictures of the flange end area? jIM
J D Race
Re: Frankencar Rear End?
Width is 61 inches measured wheel mount on drum
I think it is a car because it has control arm mounts on top that have been ground off.
Flange bolts are wider at top than bottom
I think it is a car because it has control arm mounts on top that have been ground off.
Flange bolts are wider at top than bottom
Re: Frankencar Rear End?
Ok I see it use to have upper control arm loops that were cut off the housing - It also has BOLT in axles SOoooo This is a 1971 1972 Cutlass or Skylark rear.
Good strong rear to have. YOu can buy MANY parts for this rear. JIm
Good strong rear to have. YOu can buy MANY parts for this rear. JIm
J D Race
Re: Frankencar Rear End?
Thanks Jim - this really helps me a lot.