www.jdrace.com

I have a driveshaft for a turbo 400 that is 3/4" too long. Is it possible to shorten the turbo 400 yoke instead of shortening the driveshaft. The yoke is 5 1/2" from center of u-joint to the end of the yoke. It takes the 1350 u-joint if that matters.
Thanks for any help.
Butcher

Hi Jim,
The weld job on my 10 bolt was great. I dont have time to assemble my 10 bolt. If your not too busy, can you send your phone number to my email (gerlith@roadrunner.com) to see if you have time to assemble it and when I can drop the parts off at your house.
Thanks for any help,
Butch

Jim, that was a quick reply. I have a 70 bird with a 455 that goes 11 flat at 122. It had a stock 8.5 10 bolt and I figured I was living on borrowed time. I bought Moser axles and an Eaton posi for it. I wanted to put in a Toms differential bearing cap which I have not bought yet, and weld the tubes...

Hi Jim,
Do you weld axle tubes and do machine work for new bearing caps at your shop? If so, what would a ballpark figure be for the work. I live in NE Ohio so I can bring the 10 bolt in.
Thanks for any help.
Butch