www.jdrace.com

Have a Buick Riviera rear end sitting in the garage with the following ring gear number 41812 GM KH 334 1, my math by counting gears say 3,42:1.
Anywhere I can get the number translated?
Regards Anton

Is it possible to fit a -71 Riviera rear end under a -65 A-body?
And if so what would it take?
Br Anton

Thx so much John. I am sorry for not getting back with you until now (been abroad working). Anyhow things took a slight turn this weekend when I found a 1971 Buick Riviera GS 9.5" 3.42:1 posi. rear end that I got for $100.00... at a neighbors garage!!!!!!! (lived here for 6 years and did not kn...

Jim,

You can e-mail me a quote on texasekberg@hotmail.com
Br Anton

Jim,

That terminal is not too far from me, I can pick it up there no problem.
Yes that would be a good solution with dual pattern for 0.480" knurl and
a threaded pattern.
So what would my total come up to then?
Br Anton

Jim, 3/4" overall (3/8" per side), is the knurl on the 7/16" and the 1/2" wheel studs the same size? because as of right now I just have my Buick Rally wheels and they will not accommodate the 1/2" wheel studs. Kingwood, TX 77345, this is not commercial but we can of load a ...

Jim, I was wondering about the 12 bolt 3/4" shorter then std. GM A-body 1965 with FORD ends and ready for my GM 9 1/2" drum brakes. 3.73:1 good gears and posi. 1330 yoke and a TA type rear cover. all painted, built and set up by you and send to Kingwood, TX. This will go under my -65 Buick...

Jim, Well the 1350 route we have to forget (cannot fit that drive shaft in between my mufflers without cutting and redo the whole thing). How much tourqe and hp can a 2.5" drive shaft hold in a 3700lb car? Any input on a good spherical bearing upper control arm set up? Ok, what would your price...

Jim, It needs to be set up for my Buick 9 1/2" drum brakes that I have today (less then 500 miles since all new), I guess I can spray it with a durable polyurethane chassie black paint instead of the powder coating. Also I have a 3,5" alu. universal shaft with 1350 U-joints I was planning ...

Thanks for the reply Jim.. This is mostly a street cruiser but occasionally we have some track days for the club and you know now how the horns grow when you get to the track.......and I am building a stouter motor too.. One of my issue is the rim combo I run, I use the Buick Ralleys 15X8 with 275X5...

Ok Iong story short... Trying to find a good stronger GM non c-clip rear end for my -65 Skylark. At the moment I am using my -65 Skylark GS 3.08:1 posi. 10 bolt 8.2 bolt in axels behind the 500hp / 550ftlb 455 Buick and th400 transmission on 275 drag radials. I have heard that the -65 GS rear ends a...