2003 GMC Jimmy....
http://i1149.photobucket.com/albums/o590/bluephoton2010/GEDC0125.jpg
Short version : After changing outer axle bearings noticed about a 1/4 inch of cam gear were missing in the G80 carrier where the govenor connects to, removed just the G80 carrier, never touched pinion at all ...
Search found 4 matches
- Fri Aug 10, 2012 3:51 pm
- Forum: 10 Bolt Differential Questions
- Topic: A few Questions....
- Replies: 7
- Views: 27548
- Thu Aug 09, 2012 7:53 pm
- Forum: 10 Bolt Differential Questions
- Topic: A few Questions....
- Replies: 7
- Views: 27548
Re: A few Questions....
Sorry for the measuring backlash mistake, a retarded moment on my part, obviously you want to measure the gap between the pinion and ring gears as they mesh together, too little and it pushes out the oil and they overheat and can break, too much and they make noise and can break.... and you measure ...
- Mon Aug 06, 2012 8:03 pm
- Forum: 10 Bolt Differential Questions
- Topic: A few Questions....
- Replies: 7
- Views: 27548
Re: A few Questions....
Its a GMC Jimmy so S10 Blazer, same thing...
No plans on beating it, it's my winter truck, my appologies for wasting a fine differential that could of gone into a nice street car, we can only hope it didnt have any aspirations of being a diff in a 10 sec 1/4 mile car.... lol.
So to confirm ...
No plans on beating it, it's my winter truck, my appologies for wasting a fine differential that could of gone into a nice street car, we can only hope it didnt have any aspirations of being a diff in a 10 sec 1/4 mile car.... lol.
So to confirm ...
- Sat Aug 04, 2012 2:46 pm
- Forum: 10 Bolt Differential Questions
- Topic: A few Questions....
- Replies: 7
- Views: 27548
A few Questions....
Well what started as a" brake job", then an "emergency brake job", then a "change the backing plates job" turned into a "change the outer rear axle bearings and seal job" and ultimately decided to be a "change the whole rear diff job " as I slid the axles back in after changing the outer bearings ...